COKE PETROLEUM CALCINED SWK LORESCO 50 LB BAG (70#/cuft) IMPRESSED CURRENT BACKFILL

Available

Order by:

Corrosion Service offers a full line of Loresco® earth contact backfills and related products which are designed and produced exclusively for the corrosion industry. All Loresco® backfills begin with high-quality carbons that are calcined to exacting standards. These carbons are further processed to enhance various properties depending upon the specific application or field conditions.

SWK® 

Has particle sizes ranging from 0.1 to 12mm. SWK® is heavy and sinks readily in water or light mud. It can be installed by pouring around the anodes, and tamping is not necessary.

The particles of SWK® exhibit a hard, round shape and are composed of almost solid carbon. The bulk density of SWK® is seventy pounds per cubic foot, and the porosity is forty-four percent. SWK® is a product designed specifically for use around anodes in the earth.

Its low resistivity enables intimate anode contact and assures that most electrolytic discharge will occur at the backfill periphery. According to EPA-approved leacherate tests, SWK® meets all purity requirements for materials utilized in burial.


Loresco SWK® may be poured freely in dry applications. Tamping is not required. if SWK® is poured through water or light mud, the rate of pouring should not exceed the rate of SWK®'s wetting and sinking. The rate of pouring through water will be approximately one hundred pounds per two minutes.

Horizontal Installation Procedure:

  • Have a reasonably clean ditch (design usually calls for a ditch one foot wide).
  • Pour Loresco SWK® in a continuous layer six inches deep (or as specified).
  • Place anodes on top of SWK®.
  • Pour SWK® in a continuous layer until anodes are covered by a six inch backfill cover (or as specified).
  • Fill the remainder of the ditch as specified.

Vertical Installation Procedure:

  • Have a reasonably clean hole (depth depending on soil resistivity).
  • Place one foot of SWK® in bottom of hole.
  • Lower and center anode in proper position.
  • Pour SWK® over anode until design level is reached.
  • Fill remainder of hole as design specifies.

Specifications:

  • Bulk Density: 70 lbs. per cubic foot.

  • Particle Sizing: Ranging from 0.1 to 12mm.

Shipping Data:

Loresco SWK® is shipped in fifty (50) pound (22.7 kg) coated, woven polypropylene bags. SWK® may be stored outside for limited periods (not to exceed four hundred hours of sunlight). Pallets are available with fifty bags per pallet. Proven export packaging is also available.

This product has yet to be reviewed

To be the first to review this product simply fill out the form to the left and let us know how you feel about this product!


To estimate the freight on this item simply enter the destination postcode and the desired quantity and click the "estimate" button.